Yacht Skipper Certification Course

Log in to access the course.

LOGIN PANEL

Module 1 Yacht Inland Skipper Course - Practice Test
Unit 0 Yacht Inland Skipper Course - Practice Test  
Powered By WP Courseware

Sample practice test, you must be logged in to take the practice test.
Demo version
To move on to the next stage, you must correctly answer at least 10 of 19 questions below (minimum 50%) Single-choice test. One of the three answers is correct. Select the correct one.
Question 1: The rubber components used to protect the sides are:
  • sejzing
  • padding
  • fenders
Question 2: The figure shows:
  • turnbuckle
  • triple fairlead
  • staysail
Question 3: The material made of polyester resin and fiberglass used in yacht hulls is:
  • Poliglass
  • laminate
  • epoxy
Question 4: The rudder control device may be:
  • rockweed
  • triggerwot
  • triggerfish
Question 5: Hatches are:
  • hatches used for communication between the deck and the cabin
  • openings in the false side allowing for the passage of a rope, e.g., an anchor or mooring line
  • side windows
Question 6: The rudder blade on an inland centerboard yacht is attached to the yacht by:
  • yokes
  • a tiller
  • a floor
Question 7: Two yellow, isophase lights, positioned one above the other, indicate:
  • the center of the fairway
  • a requirement for vessels proceeding along the main route to change speed when other vessels are leaving a port or side waterway
  • prohibition on generating high waves
Question 8: A buoy shaped like a sphere with horizontal red and green stripes indicates
  • dangerous place
  • the point where the navigable channel approaches the shore
  • a branching point in the waterway
Question 9: Rarely found on waterways, ramps are used to
  • allow aquatic fauna to migrate between bodies of water
  • transport ships between two bodies of water
  • generate electricity at natural height differences between bodies of water
Question 10: The following is used to charge the battery:
  • nozzle
  • generator
  • charger
Question 11: A pull cord is another name for:
  • an outboard engine starter cord
  • scraps
  • choke lever
Question 12: Permission to enter the lock is given by
  • two red lights—one above the other
  • green light over red light
  • one green light
Question 13: The lower part of a yacht’s deck where the crew stays while sailing is:
  • cockpit
  • locker
  • forpeak
Question 14: The symbol shown represents
  • a requirement to exercise extreme caution
  • the maximum permissible length of a vessel navigating a given body of water
  • a limited width of a navigable waterway or channel
Question 15: The ends of the boom are:
  • nock and heel
  • tack and the heel
  • peak and the guard
Question 16: The upper end of the mast is called:
  • top
  • peak
  • nock
Question 17: The gates of the lower lock are located
  • on the side of the tank with the lower water level
  • on the side of the tank with the higher water level
  • on the stern side of the ship
Question 18: The main longitudinal structural element of the yacht is:
  • keel (also known as the keel)
  • bow stem
  • brocket
Question 19: The junction between the side and the bottom is called:
  • bilge
  • transom
  • sternpost
0%

Log in and check

You must be logged in to see the test result.